Welcome: Guangzhou CN CNC Tools Co., Ltd
   Home  >  BLOGS

News

CNC machining experience

I. General principles of the knife path.


Roughing: In the vast majority of cases under the maximum load of the machine, the largest possible tool, with the largest possible feed, should be used, and the fastest possible feed should be used. In the case of the same tool, the feed is inversely proportional to the amount of feed. Under normal circumstances, the load of the machine is not a problem, the principle of knife selection mainly depends on the product of the two-dimensional angle and three-dimensional arc is too small to consider. After the selection of a good tool, it will set the tool length, the principle is that the tool length is greater than the depth of machining, large workpieces are to consider whether the collet interference.

PREVIOUS:The advantages and disadvantages of CNC machine tool hard rails and line rails NEXT:How to overcome deformation of thin-walled parts by CNC turning?

CATEGORIES

CONTACT US

Contact: Jacky Wang

Phone: +86 14714816052

Tel: +86 14714816052

Email: [email protected]

Add: Floor 1, Shixi Industrial area, Canton, Guangdong, China. 510288

Scan the qr codeClose
the qr code